Read JBL AUTHENTICS L8 (serv.man2) EMC - CB Certificate online
TEST REPORT
Report No.:
EM201300650-1
Application No.:
ZJ00032008
Applicant:
Harman International Industries, Incorporated
Applicant
Address:
Address:
Sample
Description:
Description:
Active speaker system with wireless streaming
Model:
AUTHENTICS L16
Adding model:
AUTHENTICS L8
Test Specification:
EN300328:2006 V1.7.1 Electromagnetic compatibility and Radio spectrum
Matters (ERM); Wideband transmission systems; Data transmission equipment
operating in the 2.4 GHz ISM band and using wide band modulation
techniques; Harmonized EN covering essential requirements under article 3.2
of the R&TTE Directive
Matters (ERM); Wideband transmission systems; Data transmission equipment
operating in the 2.4 GHz ISM band and using wide band modulation
techniques; Harmonized EN covering essential requirements under article 3.2
of the R&TTE Directive
Test Date
2013-08-08 to 2013-09-09
Issue Date:
2013-09-10
Test Result:
PASS
Prepared By:
Reviewed By:
Approved By:
Lynn Xiao/ Test Engineer
Jane Cao / Technical Support
Gavin Wu / Manager
Date:2013-09-10
Date:2013-09-10
Date:2013-09-10
Other Aspects:
None
Abbreviations: ok / P = passed; fail / F = failed; n.a. / N = not applicable
The test result in this test report refers exclusively to the presented test sample. This report shall not be reproduced except in full, without the written
approval of GRGT.
approval of GRGT.
GRG Metrology and Test Co., Ltd.
Address: 163, Pingyun Road, West of Huangpu Avenue, Guangzhou, Guangdong, P.R. China
Tel:+86-20-38699960 Fax:+86-20-38695185
Email:
Ver.:2.0/ 01. Jan. 2013
Report No.: EM201300650-1 Application No.: ZJ00032008 Page 2 of 42
DIRECTIONS OF TEST
1. This station carries out test task according to the national regulation of
verifications which can be traced to National Primary Standards and BIPM.
2. The test report merely corresponds to the test sample. It is not permitted to
copy extracts of these test result without the written permission of the test
laboratory.
3. If there is any objection concerning the test, the client should inform the
laboratory within 15 days from the date of receiving the test report.
Report No.: EM201300650-1 Application No.: ZJ00032008 Page 3 of 42
Table of Contents
1. TEST RESULT SUMMARY ......................................................................................................................................... 4
2. GENERAL DESCRIPTION OF EUT .......................................................................................................................... 5
2.1 APPLICANT .......................................................................................................................................................... 5
2.2 MANUFACTURER ............................................................................................................................................... 5
2.3 BASIC
DESCRIPTION
OF
EQUIPMENT
UNDER
TEST ................................................................................... 5
2.4 TEST
OPERATION
MODES ................................................................................................................................ 5
2.5 LOCAL
SUPPORTIVE
INSTRUMENTS ............................................................................................................. 5
3. LABORATORY AND ACCREDITATIONS ............................................................................................................... 6
3.1 LABORATORY ..................................................................................................................................................... 6
3.2 ACCREDITATIONS ............................................................................................................................................. 6
3.3 MEASUREMENT
UNCERTAINTY ..................................................................................................................... 6
3.4 LIST
OF
USED
TEST
EQUIPMENT
AT
GRGT ................................................................................................... 7
4. RADIO TECHNICAL REQUIREMENTS SPECIFICATION .................................................................................. 8
4.1 MAXIMUM
TRANSMIT
POWER ........................................................................................................................ 8
4.1.1
LIMITS .......................................................................................................................................................... 8
4.1.2
TEST METHOD ............................................................................................................................................ 8
4.1.3
TEST SETUP ................................................................................................................................................. 8
4.1.4
TEST RESULTS ............................................................................................................................................ 9
4.2 MAXIMUM
E.I.R.P.
SPECTRAL
DENSITY ...................................................................................................... 11
4.2.1
LIMITS ........................................................................................................................................................ 11
4.2.2
TEST METHOD .......................................................................................................................................... 11
4.2.3
TEST SETUP ............................................................................................................................................... 12
4.2.4
TEST RESULTS .......................................................................................................................................... 12
4.3 FREQUENCY
RANGE ........................................................................................................................................ 19
4.3.1
LIMITS ........................................................................................................................................................ 19
4.3.2
TEST METHOD .......................................................................................................................................... 19
4.3.3
TEST SETUP ............................................................................................................................................... 19
4.3.4
TEST RESULTS .......................................................................................................................................... 20
4.4
MEDIUM
ACCESS
PROTOCOL ............................................................................................................................ 24
4.4.1
LIMITS ........................................................................................................................................................ 24
4.4.2
REQUIREMENT ......................................................................................................................................... 24
4.4.3
MODULATION SPECIFICATION ............................................................................................................. 24
4.4.4 MEDIUM ACCESS PROTOCOL ..................................................................................................................... 25
4.4 TRANSMITTER
SPURIOUS
EMISSIONS ........................................................................................................ 26
4.5.1
LIMITS ........................................................................................................................................................ 26
4.5.2
TEST METHOD .......................................................................................................................................... 26
4.5.3
TEST SETUP ............................................................................................................................................... 28
4.5.4
TEST RESULTS .......................................................................................................................................... 29
4.5 RECEIVER
SPURIOUS
EMISSIONS ................................................................................................................. 33
4.6.1
LIMITS ........................................................................................................................................................ 33
4.6.2
TEST METHOD .......................................................................................................................................... 33
4.6.3
TEST SETUP ............................................................................................................................................... 35
4.6.4
TEST RESULTS .......................................................................................................................................... 36
APPENDIX A: PHOTOGRAPH OF THE TEST ARRANGEMENT ......................................................................... 38
APPENDIX B: PHOTOGRAPH OF THE EUT ............................................................................................................ 39
Report No.: EM201300650-1 Application No.: ZJ00032008 Page 4 of 42
1. TEST RESULT SUMMARY
Transmitter Part
Standard
Item
Result
EN300328:2006 V1.7.1
Maximum transmit power
4.1
PASS
Maximum e.i.r.p. spectral density
4.2
PASS
Frequency range
4.3
PASS
Media access protocol
4.4
PASS
Spurious emission from Tx
4.5
PASS
Receiver Part
Standard
Item
Result
EN300328:2006 V1.7.1 Spurious emission from Rx
5.1
PASS
