TC 1000 TAKE CONTROL (serv.man7) - Harman Kardon Audio User Guide / Operation Manual. Page 8

4

—

The com-

puter-connector port is used to establish
a serial connection between the TC1000
and a compatible computer. This connec-
tion enables your TC1000 to transfer data
to your computer, and vice versa. You can
use the computer-connector port by sim-
ply following the instructions in “Setting
Up Take Control with a Computer,”
page 14.
IR Transmitter—The infrared (IR) trans-
mitter sends an IR signal to your devices,
directing them to perform an action,
such as changing channels or volume lev-
el. When using your TC1000, you need
to point the IR Transmitter toward the
applicable device, and be within 23 feet
(7.0 m) for it to receive the IR signal.
Battery Compartment

—

The battery

compartment houses four AA alkaline
batteries. For more information on
installing and replacing the batteries, see
the instructions in “Installing the Batter-
ies,” page 6.
Reset Button

—

You can use the reset

button, located inside the battery com-
partment, to return the contrast, speaker,
and time to their predefined default set-
tings. Pressing the reset button will not
change or delete learned IR codes, activi-
ties, macros, or any customizing of but-
tons performed through the Take
Control Editor on your computer.
To use the reset button:
1 Remove the cover to the battery

compartment.

2 Using a paper clip, press the reset

button.

76009mnl2.p65

9/1/98, 2:27 PM

4

Black