Read Harman Kardon SUB-TS 1 Service Manual online
1. Speaker Level Outputs - Connect the Left, Center
and Right speakers to these connectors.
2. Speaker Level Inputs - These High Level Inputs are
for receivers that do not have line-level “pre-amp out”
or “subwoofer out” jacks. When a pair of main or
satellite speakers are attached to the OUTPUT
terminals, they are driven the full range of frequencies
as generated by the music source (receiver, amplifier,
etc.)
3. Line Level Input - These left and right Line Level
Inputs are normally used when the receiver/ processor
has line-level “pre-amp out ” or “subwoofer out” jacks.
4. Auto/On Switch - This switch allows you to set the
Mode of the Amplifier. Turn the switch to Auto to
cause it to Auto-matically turn on when it receives a
signal and Auto-matically turn off after twenty minutes
without a signal. If this switch is left “On”, the
subwoofer will always be ON when the power switch
is turned On, regardless of input signal.
5. Subwoofer Level - This knob controls the volume
level of the SUB125.
6. LED - Red & Green. The LEDs indicate the Mode
status that the subwoofer is in. When the SUB125 is
turned OFF neither LED will be lit.
The Green LED
will light when the SUB125 is ON and receiving a
signal. The Red LED will light when the amplifier has
not received a signal for twenty minutes. The
subwoofer will turn on when your receiver/amplifier
begins playing again.
7. Power Switch - This the master power switch. Use it
(in Off mode) to disconnect power to the amplifier.
8. Fuse - Use only same type of fuses. For the U.S.
120V version use only a 2A 250V fuse. For the
European 230V version use only a 1A fuse.
9. AC Cord
5
Amplifier/Subwoofer
Harman Kardon
SUB-TS1
AC 120V ,60Hz
160W
~
POWER
R
L
MIN
MAX
FUSE
STAND BY
ON
FUSE
2A/250V
TYPE T
LINE LEVEL
INPUT
SUBWOOFER
LEVEL
SPEAKER
LEVEL
OUTPUT
SPEAKER
LEVEL
INPUT
L
L
C
C
R
R
ON
AUTO
SUB-TS1
1
2
3
4
5
6
7
8
9
CONTROLS AND THEIR FUNCTION
Click on the first or last page to see other SUB-TS 1 service manuals if exist.