SIGNATURE 2.0 (serv.man10) - Harman Kardon Audio User Guide / Operation Manual. Page 9

5

 

SUB

1

2

3

4

5

6

SURR

CENTER

SURR

CENTER

FRONT

1

2

3

4

6

5

3

2

RS-232

115V

 

~

 60Hz

75 WATTS

IR

IN

IR

OUT

TRIGGER

OUTPUT

FM

AM

FRONT

1

1

Manufactured under license from Dolby Laboratories Licensing 
Corporation. "Dolby", "AC-3", "Pro Logic" and the Double-D symbol
are trademarks of Dolby Laboratories Licensing Corporation. 
Copyright 1992 Dolby Laboratories, Inc. All rights reserved.

SERIAL NUMBER

MODEL NO.: SIGNATURE SERIES 2.0
HARMAN KARDON
NORTHRIDGE
CALIFORNIA, USA
MADE IN USA 

  

RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR

TO REDUCE THE RISK OF FIRE 

OR ELECTRIC SHOCK DO NOT EXPOSE THIS 

EQUIPMENT TO RAIN OR MOISTURE.  

4

5

6

2

SUB

NRTL / C

LR110480

CSA E65

Connect to output 
of composite 
video sources

Connect 75-ohm
FM antenna here

Connect AM loop
antenna here

Connect to coaxial
digital audio output
of A/V sources, DVD,
HDTV, CD, etc.

Connect to optical
digital audio output
of A/V sources, DVD,
HDTV, CD, etc.

Connect to 
composite 
video input of 
main monitor

Connect to 
composite 
video input 
of VCRs

Connect to 
S-Video input 
of main monitor

Connect to 
S-Video input 
of VCRs

Connect to analog audio 
output of A/V sources, 
CD, tuner, etc.

Connect to audio
input of VCR or
audio recorders

Connect to
a powered 
subwoofer 
or subwoofer 
amplifier

Connect to 
inputs of audio 
power amplifiers

Connect to "Trigger
In" jack on Signature
Series or other compatible
power amplifier

Connect AC Power
to non-switched
wall outlet

Connect to 
S-Video 
output 
sources

TV

Video 1

Video 2

Video 3

Tuner

CD

Tape

Aux

Cable Box, Satellite

Receiver, TV Tuner

VCR

DVD

HDTV, Satellite with Digital

Audio, Laser Disc

Tuner (internal)

CD Player

Cassette or Tape Deck

Outboard Decoder

Analog 2

Analog 1

Digital 1

Digital 2

(Internal Tuner)

Digital 3

Analog 5

6-Ch. Direct Inputs

Composite 2

Composite 1

S-Video 1

S-Video 2

Composite 2

N/A

N/A

Composite 1

1. Before proceeding, make certain that all equipment, including the 2.0, is unplugged from AC power. This will prevent

any damage due to the unintended activation of automatic turn-on circuits.

2. Use high-quality audio and video interconnect cables to connect your source equipment to the rear of the 2.0 as shown

in the diagram above and the table below. It is important to note that unlike conventional audio/video equipment, the 2.0

does not have inputs that are labeled for connection to a specific type of equipment (e.g., inputs labeled “CD,” “Tape” or

“VCR”). Instead, the 2.0 allows you to connect the analog or digital audio and composite or S-Video outputs of your source

equipment to any of the inputs. Then, using the setup procedures detailed on page 28 of this manual, you can custom

configure the input sources. However, for a quick starting point, follow the input suggestions outlined in the chart shown

below. They conform to the preset conditions for the 2.0.