Read Harman Kardon ONYX STUDIO Service Manual online
Harman Kardon Onyx Studio
Assembly procedure
Soldering and fixing Tweeter Cable-long and
Tweeter Cable-short by sequence.
Tweeter Cable-short by sequence.
Note: Do not over 5s for the soldering, and
make sure the soldering quality and tightness.
make sure the soldering quality and tightness.
9. 取 Speaker Cable 按正負極連接到 Mid
Woofer 對應位置
Connect the Speaker Cable to the Mid Woofer.
Woofer 對應位置
Connect the Speaker Cable to the Mid Woofer.
注意：紅“+”黑“-”，紅色 Cable 線對應 Mid
Woofer "+"極，黑色 Cable 線對應 Mid Woofer
"-"極；Woofer Cable-long 和 Woofer Cable-short
不可接反
Woofer "+"極，黑色 Cable 線對應 Mid Woofer
"-"極；Woofer Cable-long 和 Woofer Cable-short
不可接反
Note: Red “+” Cable with Mid Woofer "+"
Black”-“ with Mid Woofer "-" , please make sure
the direction of Woofer Cable-long and Woofer
Cable-short.
Black”-“ with Mid Woofer "-" , please make sure
the direction of Woofer Cable-long and Woofer
Cable-short.
10. 將主板對準面框螺柱，注意藍牙天線走主
板下側經過，不能接觸鼓膜
板下側經過，不能接觸鼓膜
注意：主板定位孔需對到位
Note: Position the MB hole shown as the figure.
Note: Position the MB hole shown as the figure.
黑色在上,“-”極
紅色在下,
“+”極
紅色在上,
“+”極
黑色在下,“-”極
Woofer Cable-long
Woofer Cable-short
藍牙天線理在螺柱內
側，不能接觸鼓膜
排線走螺柱
內側
排線走螺柱內側
Click on the first or last page to see other ONYX STUDIO service manuals if exist.