Read Harman Kardon MS 150 (serv.man4) Service Manual online
English
7
1. Carefully unpack the MS 150, the FM antenna, the analog and digital audio cables,
the power supply and detachable cable, the dock for iPod/iPhone and inserts, and the
remote control and batteries.
2. Install the batteries in the remote control, following the “+” and “–” symbols in the
battery compartment to maintain the correct polarity.
CAUTION: There is danger of an explosion if a battery is incorrectly replaced. Replace
CAUTION: There is danger of an explosion if a battery is incorrectly replaced. Replace
only with the same or equivalent type.
3. Connect the FM antenna to its terminal.
4. Plug the detachable dock for iPod/iPhone into the connector on the left side of the
4. Plug the detachable dock for iPod/iPhone into the connector on the left side of the
MS 150.
Snap in the adapter that matches your iPod/iPhone, referring to the table below.
To remove an adapter, insert a flathead screwdriver into the slot at the rear of the adapter
and pry it up.
5. The MS 150 features four audio inputs for other devices, such as portable players. This
step is optional, and may be skipped if you have no external devices. If you have a player
with:
3.5mm
•
(1/8") Analog audio output or headphone jack: Plug the
included analog audio cable into the player's output or headphone jack
and either the front- or rear-panel mini jack on the MS 150. both inputs
may be used simultaneously for different devices. A second cable must be
purchased.
Pair of RCA-type analog audio outputs:
Pair of RCA-type analog audio outputs:
•
Plug one end of a stereo
RCA-type interconnect cable (not included) into the player, and the other
end into the Auxiliary Input jacks on the rear-panel of the MS 150. Use the
same color connector for each channel (usually red for right and white or
black for left).
Optical-digital audio S/P-DIF output:
Optical-digital audio S/P-DIF output:
•
Plug one end of the included
digital audio cable into the player, and the other end into the Analog/
Optical Input on the rear panel of the MS 150. Remember to select the
digital input as the source.
6. If you have purchased an optional powered subwoofer that is equipped with a line-
level input and a low-pass filter (crossover), connect it to the Subwoofer Output (cable
not included), or connect this output to an amplifier’s or powered speaker’s line-level
input.
7. If you will be viewing photos or videos stored on a compatible iPod/iPhone that supports
video browsing, connect either the Composite or S-Video Output (but not both) to a
display monitor.
8. Plug the included power supply into the MS 150's DC IN connector, and plug its power
cord into an unswitched AC outlet.
MS 150
Installation
///Navigation
Adapter
iPod/iPhone Model
NANO
iPod nano, 1st and 2nd generation
5G (VIDEO 60Gb)
iPod, 5th and 6th generation (60Gb, 80Gb) and iPod classic (160Gb)
5G (VIDEO 30Gb)
iPod, 5th and 6th generation (30Gb) and iPod classic (80Gb)
13
iPod nano, 3rd generation
12, 14
iPod touch and iPhone – install large bumper
0291CSK - HK MS150 OM v6.indd 7
07/06/11 10:41:10
Harman Kardon, JBL
HK MS 150+JBL MX 150/230V Service Manual
Page 8 of 64
Click on the first or last page to see other MS 150 (serv.man4) service manuals if exist.