HTFS 2 (serv.man7) - Harman Kardon Audio User Guide / Operation Manual. Page 3

ASSEMBLY  3

1. If you will be placing the HTFS 2 stands on a

hard surface, such as a wood or tile floor,
attach four of the supplied self-adhesive
rubber pads to the underside of the base in
the recesses as indicated in the drawing.

Place rubber pads or floor spikes here

2. If you will be using the HTFS 2 stands on a

carpeted surface, screw four of the supplied
floor spikes into the base using the threaded
inserts in the recesses as shown in the
drawing.

3. Following the instructions on pages 9 through

12 of the owner’s manual provided with your
HKTS system, thread the appropriate speaker
cable through the hole in the center of the
base, being careful to avoid the two screw
holes. Then feed the cable through the length
of the column from the bottom until it comes
out the top.

4. Attach the column to the base using two of

the supplied screws.
The column should be placed so that the
lower rim of the column is on that side of the
base plate where the Harman Kardon logo is.

5. Thread the speaker cable through the hole in

the center of the mounting plate, being
careful to avoid the three screw holes.

6. Attach the mounting plate to the top of the

column using two of the supplied screws.
The mounting plate tab with the third screw
hole should sit on the higher rim of the
column.

1. Unscrew the bolt that attaches the black shelf

stand to the bottom of the speaker. Store the
stand in a safe place in case it is needed for 
a future installation. The bolt will be used 
to attach the speaker to the floor stand
mounting plate.

2. Insert the speaker wires into the terminals on

the bottom of the speaker, being careful to
observe the correct polarity.

3. Place the speaker on top of the mounting

plate with the remaining screw hole lined up
with the threaded insert on the bottom of the
speaker.

4. Insert the bolt that was used for the shelf

stand up through the remaining screw hole
and into the speaker.

Repeat the assembly and speaker attachment
processes for each floor stand in your system,
and adjust the final speaker placement as
indicated in the owner’s manual supplied with
the speakers. You are now ready to enjoy your
home theater system!