Read Harman Kardon HS 350 (serv.man2) EMC - CB Certificate online
Page 65 of 67 Report No. JSH007120244-001
IEC 60825-1
Clause
Requirement – Test
Result - Remark
Verdict
Appendix no. 2
TRF No: IEC/EN 60065H
TRF originator Intertek ETL SEMKO SH
8 CLASSIFICATION
Pass
8.2
Description of laser classes
Class 1
Pass
8.3 Classification
responsibilities
Pass
8.4 Classification
rules
Pass
8.4a
Radiation of a single wavelength
N/A
8.4b
Radiation of multiple wavelengths
Pass
1). Laser product emission two or more
wavelengths in spectral regions shown as
additive in Table 5................................................:
wavelengths in spectral regions shown as
additive in Table 5................................................:
Visible and IR-A 400nm to
1400nm
1400nm
Pass
2). Laser product emission two or more
wavelengths in spectral regions not shown as
additive in Table 5................................................:
wavelengths in spectral regions not shown as
additive in Table 5................................................:
N/A
8.4c
Radiation from extended sources
Pass
Value of angular subtence
α (mrad) ....................: <1.5mrad
―
8.4d
Non-circular and multiple sources
N/A
8.4e
Time basis
Pass
i)
0.25s
N/A
ii)
100s
applied
Pass
iii)
30000s
N/A
8.4f
Repetitively pulsed or modulated lasers
Considered continuous output
(CW)
(CW)
N/A
i) exposure from a single pulse not exceeding the
AEL for a single pulse
AEL for a single pulse
N/A
ii) average power for a pulse train
N/A
iii) the average pulse energy from pulses within a
pulse train not exceeding the AEL for a single
pulse multiplied by the correction factor C
pulse train not exceeding the AEL for a single
pulse multiplied by the correction factor C
5
N/A
AEL for continued operation
used……...................:
used……...................:
N/A
Total-on-time-pulse (TOTP) method
used……......:
used……......:
N/A
9
MEASUREMENTS FOR CLASSIFICATION
Pass
9.1 Tests
Pass
9.2
Test conditions per Clause 9.2 applied
Pass
Measured laser radiation .....................................: Within Class 1 limit
(see appended table)
―
9.3 Measurement
geometry
Pass
Click on the first or last page to see other HS 350 (serv.man2) service manuals if exist.