Read Harman Kardon HKTS 210SUB EMC - CB Certificate online
Page 48 of 56
Report No.1018947
IEC60065 - ATTACHMENT
Clause
Requirement + Test
Result - Remark
Verdict
TRF No. IEC60065J
Z1
Add the following new clause after Clause 20:
Z1 Resistance to candle flame ignition
A television set shall be so designed that the likelihood of
ignition and the spread of fire caused by a candle flame is
reduced.
ignition and the spread of fire caused by a candle flame is
reduced.
NOTE 1 An apparatus with a viewing screen is not
regarded to be a television set if it is declared not to be so
by the manufacturer.
regarded to be a television set if it is declared not to be so
by the manufacturer.
This requirement does not apply to the display screen of
rear projection TV’s.
rear projection TV’s.
NOTE 2 This exemption has been allowed because this
technology is falling out of use and it is expected that
within a few years it will no longer exist. This exemption
will not be extended to other technologies.
technology is falling out of use and it is expected that
within a few years it will no longer exist. This exemption
will not be extended to other technologies.
NOTE 3 The frame around the screen is not exempted
from the requirements.
from the requirements.
Wood and WOOD-BASED MATERIAL with a thickness of
at least 6 mm is considered to fulfil the V-1 requirement
when applying CLC/TS 62441.
at least 6 mm is considered to fulfil the V-1 requirement
when applying CLC/TS 62441.
Compliance is checked according to CLC/TS 62441.
NOTE 4 The term vertical, as used in the first dash of
clause 5.2 of CLC/TS 62441, does not mean a perfectly
vertical position. It should be interpreted as any surface
that can be touched by the flame of a candle of 150 mm
height and 20mm diameter while the candle is still
touching the supporting surface. A typical candle used in
the home is assumed to be 20 mm diameter.
clause 5.2 of CLC/TS 62441, does not mean a perfectly
vertical position. It should be interpreted as any surface
that can be touched by the flame of a candle of 150 mm
height and 20mm diameter while the candle is still
touching the supporting surface. A typical candle used in
the home is assumed to be 20 mm diameter.
NOTE 5 It is expected that CLC/TS 62441 will in the
future be replaced by a standard, at which time that
standard will become applicable, subject to a vote by
National Committees at the time.
future be replaced by a standard, at which time that
standard will become applicable, subject to a vote by
National Committees at the time.
N/A
Click on the first or last page to see other HKTS 210SUB service manuals if exist.