Read Harman Kardon HKTS 20 (serv.man5) Service Manual online
9
HKTS 60BQ/230
+
–
+
–
+
–
+
–
+
–
LEFT
SUB
LFE OUT
+
–
+
–
+
–
+
–
+
–
+
–
+
–
RIGHT
SURROUND
FRONT
CENTRE
ENGLISH
Front left Speaker Cable
(White Bands)
Center Speaker Cable
(green Bands)
Surround Right Speaker Cable (gray Bands)
Receiver
Left Front
Right Front
Right Surround
Left Surround
Centre
Subwoofer
Surround left Speaker
Cable (Blue Bands)
Front Right Speaker
Cable (Red Bands)
Set Input Mode
Switch to “lFe”
lFe/Trigger Cable
(Purple ends)
Connecting the Subwoofer to a Receiver or Preamp/Processor with a
Dedicated Subwoofer Output
Use this installation method for receivers and preamp/processors that have a dedicated
subwoofer output with low-pass filtering (also called bass management). If the dedicated
subwoofer output does not have low-pass filtering, follow the instructions in Connecting
the Subwoofer to a Receiver or Preamp/Processor With Line Outputs, on page 10.
Use the lFe (purple) connector of the supplied combination lFe and trigger cable to
Use the lFe (purple) connector of the supplied combination lFe and trigger cable to
connect the HKTS 210SUB’s
Line-Level LFE In connector 6 to the dedicated subwoofer
output (or lFe output) of your receiver or preamp/processor. Set the subwoofer's
Input
Mode switch 4 to the “lFe” position.
Connect each satellite speaker and the center speaker to the corresponding speaker
terminals on your receiver or amplifier.
In your receiver or preamp/processor’s setup menu, configure the receiver or preamp/
In your receiver or preamp/processor’s setup menu, configure the receiver or preamp/
processor for “Subwoofer On,” and set the front, center and surround speakers to
“Small.” After you have made and verified all connections, plug the HKTS 210SUB’s
AC
Power cord 9 into an active AC outlet.
Speaker Connections
harman/kardon
HKTS 20/30/60 -230V Service Manual
Page 30 of 48
Click on the first or last page to see other HKTS 20 (serv.man5) service manuals if exist.