Read Harman Kardon HK 980 (serv.man5) Service Manual online
Controls and Functions
Speaker 1
Speaker 2
Source Direct
Mode
Source
Record Source
Volume
Phones
980
3
4
5
6
7
8
9
1. Power Indicator:
This LED will
illuminate in amber when the unit is in
the Standby mode to signal that the unit
is ready to be turned on.
When the unit is in operation, the
indicator will turn white.
2. System Power Control:
Press this
button to turn on the HK 980; press it
again to turn the unit off (to Standby).
Note that the Power Indicator1next to
the switch will turn blue when the unit is
on.
3. Speaker 1 /2 Selectors:
Press to
select speaker pair 1 or 2, or both, or
neither (headphone output only).
4. Input Source Selector:
Select
desired input source for listening by
press-ing the ”Input ource” button
repeatedly (on the left will select
ownwards, right upwards) until the
display for he desired source is
illuminated.
5. Source Direct:
Press to bypass tone
control circuitry.
6. Record Source Selector:
Select
desired ource for recording to device
connected to the rear panel Tape and
CDR Out sockets by pressing
the ”Record Source” button repeatedly
until the display for the desired source is
illuminated.
7. Mode Button:
Press this button to
make changes to the bass, treble and
balance settings.
8. Headphone Jack:
Plug in
headphones if desired. With
both ”Speaker 1” and ”2” selectors in the
Off position, output is supplied only to
headphones.
9. Volume Control:
Turn to raise or
lower output volume.
harman/kardon
HK 980/230 Service Manual
Page 4 of 50
Click on the first or last page to see other HK 980 (serv.man5) service manuals if exist.