HK 3700 - Harman Kardon Audio Service Manual (repair manual). Page 3

Read Harman Kardon HK 3700 Service Manual online

HK 3700/3770
Important Safety Information
4
•  aM loop antenna
•  FM Loop antenna
•  two aaa batteries
•  ac power cord
IMPORTANT: If any of these accessories is missing or if any part of your 
HK 3700/3770 system fails to operate properly, contact your dealer 
immediately.
Important Safety Information
Verify Line Voltage before Use
the HK 3700/3770 has been designed for use with 100- 240 Volt alternating current 
(ac). connection to a line voltage other than that for which your HK 3700/3770 is 
intended can create a safety and fire hazard, and may damage the unit. If you have 
any questions about the voltage requirements for your specific model or about the line 
voltage in your area, contact your selling dealer before plugging the unit into a wall 
outlet.
Do Not Use Extension Cords
to avoid safety hazards, use only the power cord supplied with your unit. we do not 
recommend the use of extension cords with this product. do not run power cords 
under rugs or carpets, or place heavy objects on them. damaged power cords should 
be replaced immediately by an authorized service center, with a cord, meeting factory 
specifications.
Handle the AC Power Cord Gently
when disconnecting the power cord from an ac outlet, always pull the plug; never pull 
the cord. If you do not intend to use your HK 3700/3770 for any considerable length of 
time, disconnect the plug from the ac outlet.
Do Not Open the Cabinet
there are no user-serviceable components inside this product. Opening the cabinet may 
present a shock hazard, and any modification to the product will void your warranty. If 
water or any metal object such as a paper clip, wire or staple accidentally falls inside the 
unit, disconnect it from the ac power source immediately, and consult an authorized 
service center.
CATV or Antenna Grounding
If an outside antenna or cable system is connected to this product, be certain that it is 
grounded so as to provide some protection against voltage surges and static charges. 
Section 810 of the united States national electrical code, anSI/nFpa no. 70-1984, 
provides information with respect to proper grounding of the mast and supporting 
structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding 
conductors, location of antenna discharge unit, connection to grounding electrodes and 
requirements of the grounding electrode.
Note to CATV System Installer: this reminder is provided to call the catV (cable
tV) system installer’s attention to article 820-40 of the nec, which provides guidelines 
for proper grounding and, in particular, specifies that the cable ground shall be 
connected to the grounding system of the building, as close to the point of cable entry 
as possible.
Placing the Stereo Receiver
•  place the Stereo receiver on a firm and level surface. be certain that the 
surface and any mounting hardware can support the Stereo receiver’s 
weight.
•  provide proper space above, below, behind and to the sides of the Stereo 
receiver for ventilation. Maintain a clearance of at least 12” (30 cm) on each 
side of, above and behind the unit.
•  If you install the Stereo receiver in a cabinet or other enclosed area, provide 
cooling air within the cabinet. under some circumstances, a fan may be 
required.
•  do not obstruct the ventilation slots on the top of the Stereo receiver or 
place objects directly over them.
•  do not place the Stereo receiver directly on a carpeted surface.
•  do not place the Stereo receiver in moist or humid locations, in extremely 
hot or cold locations, in areas near heaters or heat registers, or in direct 
sunlight.
Harman Kardon
HK 3700 Service Manual
Page 3 of 109
Page of 109
Display

Click on the first or last page to see other HK 3700 service manuals if exist.