Read Harman Kardon AVR 18 (serv.man7) User Guide / Operation Manual online
Rear Panel Connections
8
ENGLISH
ª
Phono Inputs:
Connect the
outputs of your turntable or tone arm
to these jacks. Note that only Moving
Magnet (MM) type cartridges may be
used.
to these jacks. Note that only Moving
Magnet (MM) type cartridges may be
used.
‚
Phono Ground:
Connect the
ground wire from a turntable to this
terminal to reduce system hum.
terminal to reduce system hum.
⁄
TV Monitor Video Output:
Connect this jack to the standard
(composite) video input of a TV
monitor or video projector to view the
output of any standard video source
selected by the receiver’s video
switcher.
(composite) video input of a TV
monitor or video projector to view the
output of any standard video source
selected by the receiver’s video
switcher.
¤
Speaker Terminals:
Connect
these terminals to the appropriate
terminals on your speakers.
terminals on your speakers.
‹
Switched AC Outlets:
This outlet
may be used to power any device
that you wish to have turn on when
the unit is turned on with the
that you wish to have turn on when
the unit is turned on with the
System
Power Control
switch
2.
NOTE: The power consumption of the
device plugged into these outlets
should not exceed 100 watts.
device plugged into these outlets
should not exceed 100 watts.
›
Power Cable:
Connect the AC
plug to a non-switched AC wall
output
output
fi
Video 2 Inputs:
Connect these
jacks to the audio and video outputs
of a TV Tuner, Cable TV converter
box, satellite receiver or any other
audio/video source.
of a TV Tuner, Cable TV converter
box, satellite receiver or any other
audio/video source.
fl
Video 1 Inputs:
Connect these
jacks to the audio and video
PLAY/OUT jacks of a VCR.
PLAY/OUT jacks of a VCR.
‡
Video Outputs 1:
Connect these
jacks to the audio and video
RECORD/IN jacks of a VCR.
RECORD/IN jacks of a VCR.
°
6-Channel Direct Inputs:
If an
external digital audio decoder is
used for 5.1 (Dolby Digital, DTS, etc.)
audio, connect the outputs of that
decoder to these terminals.
used for 5.1 (Dolby Digital, DTS, etc.)
audio, connect the outputs of that
decoder to these terminals.
·
AM Antenna:
Connect the AM
loop antenna supplied with the
receiver to these terminals. If an
external AM antenna is used, make
connections to the
receiver to these terminals. If an
external AM antenna is used, make
connections to the
AM
and
GND
terminals in accordance with the
instructions supplied with the
antenna.
instructions supplied with the
antenna.
a
FM Antenna:
Connect an indoor
or external FM antenna to this
terminal.
terminal.
Click on the first or last page to see other AVR 18 (serv.man7) service manuals if exist.