AVR 135 (serv.man4) - Harman Kardon Audio User Guide / Operation Manual. Page 14

This unit is equipped with two accessory AC out-
lets. They may be used to power accessory
devices, but they should not be used with high-
current draw equipment such as power ampli-
fiers. The total power draw to the Unswitched
Outlet 

 must not exceed 100 watts, that to

the Switched Outlet 

 50 watts.

The Switched

 outlet will receive power only

when the unit is on completely. This is recom-
mended for devices that have no power switch
or a mechanical power switch that may be left in
the “ON” position.

NOTE: Many audio and video products turn to
Standby mode only when they are used with
switched outlets, and cannot be fully turned on
using the outlet alone without a remote control
command.

The Unswitched

 outlet will receive power

as long as the unit is plugged into a powered AC
outlet and the Main Power Switch 1 is on.

Finally, when all connections are complete, plug
the power cord into a nonswitched 220-240-volt
AC wall outlet. You’re almost ready to enjoy the
AVR 135!

No matter which type or brand of speakers is
used, the same model or brand of speaker
should be used at least for the front-left, center
and front-right speakers. This creates a seamless
front soundstage and eliminates the possibility
of distracting sonic disturbances that occur when
a sound moves across mismatched front-channel
speakers.

The placement of speakers in a multichannel
home-theater system can have a noticeable
impact on the quality of sound reproduced.

Depending on the type of center-channel
speaker in use and your viewing device, place
the center speaker either directly above or below
your TV, or in the center behind a perforated
front-projection screen.

Once the center-channel speaker is installed,
position the left-front and right-front speakers so
that they are as far away from one another as
the center-channel speaker is from the preferred
listening position. Ideally, the front-channel
speakers should be placed so that their tweeters
are no more than 60cm above or below the
tweeter in the center-channel speaker.

They should also be at least 0.5 meter from your
TV set unless the speakers are magnetically
shielded to avoid colourings on the TV screen.
Note that most speakers are not shielded, even

with complete surround sets only the Center
speaker may be.

Depending on the specifics of your room
acoustics and the type of speakers in use, you
may find that imaging is improved by moving the
front-left and front-right speakers slightly
forward of the center-channel speaker. If
possible, adjust all front loudspeakers so that
they are aimed at ear height when you are
seated in the listening position.

Using these guidelines, you’ll find that it takes
some experimentation to find the correct
location for the front speakers in your particular
installation. Don’t be afraid to move things
around until the system sounds correct. Optimize
your speakers so that audio transitions across
the front of the room sound smooth.

When the AVR is used in 5.1-channel operation,
the preferred location for surround speakers is
on the side walls of the room, at or slightly
behind the listening position. In a 6.1-channel
system, both side surround and a back surround
speaker are required. The center of the speaker
should face you (see below).

The rear wall location may also be used in place
of side-wall mounting in 5.1 systems when it is
not practical to place the main surround speak-
ers at the sides of the room.

As with the side speakers, rear surround speak-
ers should be located so that the bottom of the
cabinet is at least two feet higher than the lis-
teners’ ears. The speakers should be no more
than six feet behind the rear of the seating area.

If dipole-type speakers are used on either the
side or rear walls of the room, please note that if
there are arrows on the speakers they should
face the front of the room for the side speakers,
or toward the center of the wall for the rear
speakers.

Subwoofers produce largely nondirectional
sound, so they may be placed almost anywhere
in a room. Actual placement should be based on
room size and shape and the type of subwoofer
used. One method of finding the optimal
location for a subwoofer is to begin by placing it
in the front of the room, about 15cm from a
wall, or near the front corner of the room.
Another method is to temporarily place the
subwoofer in the spot where you will normally
sit, and then walk around the room until you
find a spot where the subwoofer sounds best.
Place the subwoofer in that spot. You should
also follow the instructions of the subwoofer’s
manufacturer, or you may wish to experiment
with the best location for a subwoofer in your
listening room.

14 INSTALLATION AND CONNECTIONS