Read Harman Kardon AVI 200 (serv.man9) Technical Bulletin online
harman/kardon
Service Bulletin
Service bulletin # 9706 November 1997
Warranty labor rate: MINOR repair
To:
All harman/kardon Service Centers
Models: AVR 10/20/25/3250; AVI 100/150/200
Subject: Remote Control has stopped working
In the event you receive a complaint about a remote control that has stopped working, perform
the following tests:
1)
Remove the batteries and confirm they are not weak or defective (battery voltage should be 1.4 volts
or more). Replace batteries if necessary; both batteries in remote control should be replaced.
or more). Replace batteries if necessary; both batteries in remote control should be replaced.
2) Point the remote towards the corresponding receiver/amplifier and confirm the remote control
functions operate as intended.
3) If Remote Control still doesn’t work:
Remove batteries, and with an alligator clip lead or other jumper wire, short the positive and negative
tabs inside the control together. (See drawing) This short will drain any remaining charge from
the capacitors in the remote control and re-set the microprocessor.
the capacitors in the remote control and re-set the microprocessor.
4) Re-insert batteries and test the functions as per item (2) above.
NOTE: This procedure may also work for other h/k model remote controls not listed above.
harman/kardon Incorporated 250 Crossways Park Drive, Woodbury New York 11797 (516) 496-3400
Display
