AVI 100 (serv.man10) - Harman Kardon Audio User Guide / Operation Manual. Page 6

ENGLISH

Press this button to turn the power on.
Press again to turn the power off. If
you connect the other components to
the switched outlet, it can also be
used as a system power button.

Stereo headphones can be plugged
into this jack for private listening.
Headphone impedance should be
between 8 and 2K ohms. Best results
between 200 and 400 ohms.

Modifies the low-frequency sound of
the left and right channels as much as
+/- 10dB. Set this control at a suitable
position for your taste and room
acoustics.

Modifies the high-frequency sound of
the left and right channels as much as
+/- 10dB. Set this control at a suitable
position for your taste and room
acoustics.

This control is used for balancing the
relative sound volume of the left and
right channel speakers. Clockwise
rotation reduces the volume from the
left speaker, counterclockwise rotation
reduces the volume from the right
speaker.

Press this button to select the desired
surround mode. The mode is changed
between DOLBY pro-logic and
DOLBY 3-STEREO.

Defeats all surround modes.

Press these buttons to select the
desired input source.

Push this button to change center
channel modes.

Connect these jacks to the
corresponding output jacks of a VCR
or Camcorder.

Turn the VOLUME clockwise to
increase the volume and
counterclockwise to decrease it. The
volume of the front, center, and rear
channels is changed at the same
time.

This window shows the state of
operation for easier control of the
amplifier. It also contains the IR
Remote Sensor.

4

AVI100 engelsk  11/01/98 7:27  Side 4