AVAP 5G - Harman Kardon Audio User Guide / Operation Manual. Page 26

Programming the Remote

When the code has been entered using the
Auto Search method, it is always a good
idea to find out the exact code so that it
may be easily reentered if necessary. You
may also read the codes to verify which
device has been programmed to a specific
Control Selector button.

1. Press and hold both the 

∂

for the type of

product to be entered (e.g., VCR, TV)
and the 

button

at the same

time. Hold both buttons until the

å

red light stays

lit. Note that the next step must take
place while the red light is on, and it
must begin within 20 seconds after
the light illuminates.

2. Press the 

or

button 

µ

. The 

å

red light will blink in

a sequence that corresponds to the
three-digit code, with a one-second
pause between each digit. Count the
number of blinks between each pause
to determine the digit of the code.
One blink is the number 1, two blinks
is the number 2, and so forth. Ten
blinks are used to indicate a “0”.

Example: One blink, followed by a one-
second pause, followed by six blinks,
followed by a one-second pause, followed
by ten blinks indicates that the code has
been set to 160.

For future reference enter the Setup Codes
for the equipment in your system here:

TV

VCR

DVD

Once the AVR5’s remote has been pro-
grammed for the codes of other devices,
press the appropriate 

∂

to change the remote from

control over the AVR5 to the additional
product. When you press any of the

, the 

å

will briefly flash in red to

indicate that you have changed the device
being controlled.

When operating a device other than the
AVR5, the controls may not correspond
exactly to the function printed on the
remote or button. Some commands, such
as the volume control, are the same as
with the AVR5. Other buttons will change
their function so that they correspond to
a secondary label on the remote. For
example, the Surround Mode selector
buttons also function as the Channel Up
and Channel Down buttons when operat-
ing most TV sets or VCRs. The Channel
Up/Down indication is printed directly on
the remote. The same is true for standard
VCR and DVD functions, which follow the
standard function icons printed on top of
the buttons.

For some products, however, the function
of a particular button does not follow the
command printed on the remote. In
order to see which function a button con-
trols, consult the Function List tables
printed in this manual. To use those
tables, first check the type of device being
controlled (e.g., TV, VCR). Next, look at
the remote control diagram pictured on
the following page. Note that each button
has a number on it.

27

AVR 5 RC

1

3

2

31

30

4

5

7

9

10

11

27

28

26

12

15

17

18

24

25

23

22

21

20

19

14

13

8

6

29

16

AVR5 om (e)  2/5/99  10:38 AM  Page 27