Read Sony SLV-ED22KR / SLV-ED22PL / SLV-ED22TW / SLV-ED55KR / SLV-ED55PL / SLV-ED88TW / SLV-ED99KR / SLV-ED99PL / SLV-ED99TW Service Manual online
1-1
SECTION 1
GENERAL
This section is extracted from SLV-
ED22KR/ED55KR/ED99KR instruction
manual. (3-058-932-11)
ED22KR/ED55KR/ED99KR instruction
manual. (3-058-932-11)
SLV-ED22/ED55/ED88/ED99
Getting Started
4
Getting Started
Step 1
Unpacking
Check that you have received the following items with the VCR:
• Remote commander
• Size AA (R6) batteries
• 75-ohm coaxial cable with F-type
connectors
• Plug adaptor
Checking your model name
The instructions in this manual are for the 3 models: SLV-ED99PL,
ED55PL and ED22PL. Check your model number by looking at the
rear panel of your VCR. SLV-ED99PL is the model used for illustration
purpose. Any difference in operation is clearly indicated in the text,
for example,“SLV-ED22PL only.”
ED55PL and ED22PL. Check your model number by looking at the
rear panel of your VCR. SLV-ED99PL is the model used for illustration
purpose. Any difference in operation is clearly indicated in the text,
for example,“SLV-ED22PL only.”
5
Getting Started
Getting Started
Inserting the batteries
Insert two size AA (R6) batteries by
matching the + and – on the batteries
to the diagram inside the battery
compartment.
matching the + and – on the batteries
to the diagram inside the battery
compartment.
Insert the negative (–) end first, then
push in and down until the positive
(+) end clicks into position.
push in and down until the positive
(+) end clicks into position.
Using the remote commander
You can use this remote
commander to operate this VCR
and a Sony TV. Buttons on the
remote commander marked with
a dot (•) can be used to operate
your Sony TV. If the TV does not
have the g symbol near the
remote sensor, this remote
commander will not operate the
TV.
commander to operate this VCR
and a Sony TV. Buttons on the
remote commander marked with
a dot (•) can be used to operate
your Sony TV. If the TV does not
have the g symbol near the
remote sensor, this remote
commander will not operate the
TV.
Step 2
Setting up the remote commander
To operate
the VCR
a Sony TV
Set TV / VIDEO to
VIDEO and point at the remote sensor on the VCR
TV and point at the remote sensor on the TV
Remote sensor
TV
/
VIDEO
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove
the batteries to avoid possible damage from battery leakage.
• Do not use a new battery with an old one.
• Do not use different types of batteries.
• Do not use different types of batteries.
1
2
3
continued
Getting Started
6
Controlling other TVs with the remote commander
(SLV-ED99PL only)
(SLV-ED99PL only)
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer’s code
number.
TV is listed in the table below, set the appropriate manufacturer’s code
number.
1
Set TV / VIDEO at the top of the remote commander to TV .
2
Hold
?/1 down, and enter your TV’s code number(s) using the number
buttons. Then release
?/1.
Now you can use the
?/1, VOL +/–, CH +/– and TV/VIDEO buttons to
control your TV. You can also use the buttons marked with a dot (
•
) to
control a Sony TV. To control the VCR, reset TV / VIDEO to VIDEO .
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until
you find the one that works with your TV.
you find the one that works with your TV.
Step 2: Setting up the remote commander (continued)
Notes
• If the TV uses a different remote control system from the one programmed to work
• If the TV uses a different remote control system from the one programmed to work
with the VCR, you cannot control your TV with the remote commander.
• You may not be able to use some buttons to control non-Sony TVs due to the remote
commander’s signal limitations.
• If you enter a new code number, the code number previously entered will be erased.
• When you replace the batteries of the remote commander, the code number may
• When you replace the batteries of the remote commander, the code number may
automatically reset to 01 (Sony). If your TV is not a Sony, it is recommended to
manually set the appropriate code number every time you replace the batteries.
manually set the appropriate code number every time you replace the batteries.
Manufacturer
Sony
Akai
AOC
Centurion
Colonad
Curis-Mathes
Emerson
Fisher
General Electric
Gold Star
Hitachi
JVC
Magnavoc
Marantz
Code number
01
04
04
12
03
12
03, 04, 14
11
06, 10
03, 04, 17
02
09
08
13
Manufacturer
MGA/Mitsubishi
Panasonic
Philips
Pioneer
Quasar
Radio Shack
RCA
Sanyo
Sears
Sharp
Sylvania
Teknika
Toshiba
Zenith
Code number
13
06, 19
08
16
06
05, 14
10
11
07, 11
05, 18
08
14
07
15
7
Getting Started
Getting Started
Step 3
Hookup
Audio/video (A/V) hookup
If your TV has audio/video (A/V) input jacks, you will get a better picture
and sound when you hook up your VCR using these connections. If your TV
doesn’t have A/V inputs, see the following page for antenna hookup.
and sound when you hook up your VCR using these connections. If your TV
doesn’t have A/V inputs, see the following page for antenna hookup.
For SLV-ED99PL only
For a true “home theater” experience, you should connect the audio outputs
of your VCR or TV to your stereo system.
of your VCR or TV to your stereo system.
A Use this hookup if your TV has stereo jacks
B Use this hookup if your TV doesn’t have stereo jacks
VCR
Stereo receiver
Audio/video cable (not supplied)
TV
TV
VCR
Stereo receiver
Video cable (not supplied)
Audio cable (not supplied)
Audio cable (not supplied)
IN
VIDEO
AUDIO
AUDIO OUT
AUX IN
AUDIO VIDEO
LINE-2
OUT
LINE-1
OUT
OUT
LINE-1
OUT
VIDEO
AUDIO
IN
AUX IN
AUDIO VIDEO
LINE-2
OUT
LINE-1
OUT
OUT
LINE-1
OUT
TV
VCR
Stereo receiver
Video cable (not supplied)
Audio cable (not supplied)
VIDEO
AUDIO
IN
AUX IN
AUDIO VIDEO
LINE-2
OUT
LINE-1
OUT
OUT
LINE-1
OUT
or
continued
Click on the first or last page to see other SLV-ED22KR / SLV-ED22PL / SLV-ED22TW / SLV-ED55KR / SLV-ED55PL / SLV-ED88TW / SLV-ED99KR / SLV-ED99PL / SLV-ED99TW service manuals if exist.