KV-SW213M81 - Sony TV Service Manual (repair manual). Page 8

– 7 –

CAUTION :
1.  Do not overpull the wires during dressing

--> avoid disconnection of wires.

2.  Make sure wires are kept away from

sharp edges, heatsinks & other
high-temperature parts.

A

CN801

C

W068

W069

R828

R829

R889

UL wire

P/N 1-923-082-52

Ensure UL wire does not touch high
temperature resistors R828, R829 & R889

W052

Lead Assy, Jumper

Conn Assy, 5P (YUV)

Make sure the UL tape is

positioned

at the sharp edge of

shield case to

prevent wire from being

scratched

Connector Assy, 5P & Lead Assy, 

Jumper go around shield case &

dress with pin wire A021

R121

Lead Assy, G2 & 200V wire on C Board UL wire P/N 1-923-082-52 on A Board (W068-W069)

CAUTION:
Dress & control mounted wires (Lead Assy, G2 & 200V wire) on C  board
if necessary :
--> ensure wires do not get trapped during solder dip process
--> ensure wires do not get punched by ICT jig (modify ICT jig if applicable)

CAUTION:
1) Make sure wires are kept
away from sharp edges &
heatsinks
2) Keep UL wire close to
board surface
3) Make sure wires are kept
away from high-temperature
parts
4) Ensure wires do not get
punched by ICT jig (modify
ICT jig if applicable)

CN703:
Ensure Pin 
1 is 
connected
to orange
wire 
(200V)

W700:
Board-
in Lead
Assy, 
G2

W051

Keep UL wire close to
board surface --> vertical
seam improvement

Make sure Conn Assy, 5P

does not touch resistor, R121

Keep Lead Assy, Jumper

away from shield case -->

C/M for OSD drift from RF to

Video mode

Make sure the Connector Assy,

5P is kept close to board surface.

CAUTION:
1) Dress Lead Assy, Jumper according to the green route.
  => Ensure Lead Assy, Jumper is dress away from shield case in the boxed area.
  => Ensure Lead Assy, Jumper is dress below Conn Assy, 5P (YUV).
2) Make sure wires are kept away from sharp edges, heatsinks & other high-temperature parts