Read Sony DSC-F717 (serv.man4) Service Manual online
DSC-F717
6-4
1-1-2.
Preparations
Note 1:
For details of how remove the cabinet and boards, refer
to “2. DISASSEMBLY”.
to “2. DISASSEMBLY”.
Note 2:
When performing only the adjustments, the lens block
and boards need not be disassemble.
and boards need not be disassemble.
1) Connect the equipment for adjustments according to Fig. 6-1-
6.
2) Connect the Adjusting remote commander to the FR-194 board
CN305 via CPC-12 jig (J-6082-436-A). (See Fig. 6-1-3)
Note 3:
Setting the “Forced CAMERA mode power ON” Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 21, set data: 07, and press
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 21, set data: 07, and press
the PAUSE button of the adjusting remote com-
mander.
The above procedure will enable the camera power
to be turned on. After completing adjustments, be
sure to exit the “Forced CAMERA mode power ON
Mode”.
mander.
The above procedure will enable the camera power
to be turned on. After completing adjustments, be
sure to exit the “Forced CAMERA mode power ON
Mode”.
Note 4:
Exiting the “Forced CAMERA mode power ON Mode”
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 21, set data: 00, and press
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 21, set data: 00, and press
the PAUSE button of the adjusting remote com-
mander.
mander.
3) Select page: 0, address: 01, and set data: 00.
1-1-3.
Discharging of the Flashlight Power Supply
The capacitor which is used as power supply of flashlight is charged
with 200 V to 300 V voltage. Discharge this voltage before start-
ing disassembly in order to protect service engineers from electric
shock during disassembly.
with 200 V to 300 V voltage. Discharge this voltage before start-
ing disassembly in order to protect service engineers from electric
shock during disassembly.
Discharge procedure
1. Remove the FR-194 board, and disconnect the harness from
1. Remove the FR-194 board, and disconnect the harness from
CN404 on the BT-015 board.
2. Fabricate the short jig as shown in Fig. 6-1-5 locally by your-
self. Connect the short jig to the pin 1 and pin 2 of CN404
on the BT-015 board. Allow ten seconds to discharge the volt-
age.
on the BT-015 board. Allow ten seconds to discharge the volt-
age.
Fig. 6-1-5
Fig. 6-1-3
1 k
Ω
/1 W
Wrap insulating tape.
Fig. 6-1-4
Fig. 6-1-2
R:1 k
Ω
/1 W
(Part code:
1-215-869-11)
1-215-869-11)
CN404
BT-
015
Harness
CPC cover
CPC-12 jig
(J-6082-436-A)
(J-6082-436-A)
FR-194 board
CN305
CN305
22
1
Front of the lens
Pattern box
L
L=About 30 cm
Click on the first or last page to see other DSC-F717 (serv.man4) service manuals if exist.