Read Sony MEX-BT2500 Service Manual online
MEX-BT2500
27
27
MEX-BT2500
SECTION 5
DIAGRAMS
•
Note for Printed Wiring Boards and Schematic Diagrams
Note on Schematic Diagram:
•
All capacitors are in
µ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
and tantalums.
•
All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
• C
: panel designation.
• A
: B+ Line.
•
Power voltage is dc 14.4V and fed with regulated dc power
supply from ACC and BATT cords.
supply from ACC and BATT cords.
•
Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : TUNER
(
under no-signal (detuned) conditions.
no mark : TUNER
(
) : CD PLAY
•
Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
tion tolerances.
•
Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
Voltage variations may be noted due to normal produc-
tion tolerances.
•
Circled numbers refer to waveforms.
•
Signal path.
F
: AUDIO
f
: TUNER
J
: CD PLAY
p
: BLUETOOTH OUT
l
: BLUETOOTH IN
N
: MIC
E
: AUX IN
•
Abbreviation
CND : Canadian model
CND : Canadian model
Note on Printed Wiring Board:
• X
: parts extracted from the component side.
• Y
: parts extracted from the conductor side.
•
f
: internal component.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Pattern face side:
Parts on the pattern face side seen from
(Side B)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Side A)
the parts face are indicated.
Caution:
Pattern face side:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side)
the parts face are indicated.
•
Circuit Boards Location
Note:
The components identi-
fied by mark
The components identi-
fied by mark
0
or dotted
line with mark
0
are criti-
cal for safety.
Replace only with part
number specified.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque
Les composants identifiés par
une marque
0
sont critiques
pour la sécurité.
Ne les remplacer que par une
pièce por tant le numéro
spécifié.
Ne les remplacer que par une
pièce por tant le numéro
spécifié.
MAIN board
SENSOR board
SERVO board
KEY board
front panel section
main unit section
TUNER UNIT
(TU1)
(TU1)
BT board
ANTENNA board
Click on the first or last page to see other MEX-BT2500 service manuals if exist.