CDX-GT120, CDX-GT220, CDX-GT22W - Sony Car Audio Service Manual (repair manual). Page 5

Read Sony CDX-GT120 / CDX-GT220 / CDX-GT22W Service Manual online

5
CDX-GT22W/GT120/GT220
SECTION 2
GENERAL
• LOCATION OF CONTROL
• CONNECTIONS
This section is extracted
from instruction manual.
Connection example  
Notes (
2
-A)
Be sure to connect the ground (earth) lead before connecting 
the amplifi er.
The alarm will only sound if the built-in amplifi er is used.
Tips (
2
-B)
When connecting only a single CD/MD changer or other 
optional device, connect directly to this unit.
For connecting two or more CD/MD changers or other 
optional devices, the source selector XA-C40 (not supplied) is 
necessary.
Exemple de raccordement  
Remarques (
2
-A)
Raccordez d’abord le câble de mise à la masse avant de 
raccorder l’amplifi cateur.
L’alarme est émise uniquement lorsque l’amplifi cateur intégré 
est utilisé.
Conseils (
2
-B)
En cas de raccordement d’un seul changeur de CD/MD 
uniquement ou d’autres appareils en option, raccordez-le/les 
directement à cet appareil.
Le sélecteur de source XA-C40 (non fourni) est nécessaire 
pour raccorder deux changeurs de CD/MD ou plus ou d’autres 
appareils en option.
A
B
AUDIO OUT REAR
*
AUDIO OUT FRONT
AUDIO OUT REAR
*
AUDIO OUT FRONT
BUS AUDIO IN
BUS CONTROL IN
Source selector
*
Sélecteur de source
*
XA-C40
*
 not supplied
  non fourni
*
 AUDIO OUT SUB/REAR
CDX-GT320/GT32W 
CDX-GT320/GT32W 
*
 AUDIO OUT SUB/REAR
CDX-GT320/GT32W 
7
J
DSPL (display)/SCRL (scroll) button 
(CDX-GT320/GT32W/GT220/GT22W)  
page 8
To change display items (press); scroll the 
display item (press and hold). 
DSPL (display) button (CDX-GT120/
GT12W)
  
page 8
To change display items.
K
SEEK –/+ buttons
CD:
To skip tracks (press); skip tracks 
continuously (press, then press again within 
about 1 second and hold); reverse/fast-
forward a track (press and hold).
Radio:
To tune in stations automatically (press); find 
a station manually (press and hold).
L
MODE button  page 8
To select the radio band (FM/AM)*.
M
BTM/CAT button (CDX-GT320/GT32W)  
page 8
To start the BTM function (press and hold).
BTM button (CDX-GT220/GT22W/
GT120/GT12W)
  
page 8
To start the BTM function (press and hold).
N
RESET button
 (located behind the front 
panel)
 (CDX-GT320/GT32W only)  
page 5
O
Number buttons
CD:
(1)
/
(2): 
ALBM –/+ 
(during MP3/WMA 
playback)
 (CDX-GT320/GT32W/GT220/
GT22W)
To skip albums (press); skip albums 
continuously (press and hold).
(3): 
REP  page 8
(4): 
SHUF  page 8
(6): 
PAUSE
To pause playback of a CD on this unit. 
To cancel, press again.
Radio:
To receive stored stations (press); store 
stations (press and hold).
P
Receptor for the card remote 
commander (CDX-GT320/GT32W/
GT220/GT22W only)
The following buttons on the card remote 
commander have also different buttons/functions 
from the unit. Remove the insulation film before 
use (page 5) (CDX-GT320/GT32W only).
qj <
 (
.
)/
,
 (
>
) buttons
To control CD/radio, the same as (SEEK) 
–/+ on the unit.
Setup, sound setting, etc., can be operated by 
< ,.
qk
DSPL (display) button
To change display items.
ql
VOL (volume) +/– button
To adjust volume.
w;
ATT (attenuate) button
To attenuate the sound. To cancel, press 
again.
wa
SEL (select) button
The same as the select button on the unit.
ws M
 (+)/
m
 (–) buttons
To control CD, the same as (1)/(2) (ALBM 
–/+) on the unit.
Setup, sound setting, etc., can be operated by 
M m.
wd
SCRL (scroll) button
To scroll the display item.
wf
Number buttons
To receive stored stations (press); store 
stations (press and hold).
*
In the case of a CD/MD changer or SAT tuner being 
connected; when 
(SOURCE)
 is pressed, the 
connected device (“MD,” “XM” or “SR”) will appear in 
the display, depending on which device is 
connected. Furthermore, if 
(MODE)
 is pressed, you 
can switch the changer, or SAT tuner band (CDX-
GT320/GT32W only).
Note
If the unit is turned off and the display disappears, it 
cannot be operated with the card remote commander 
unless 
(SOURCE)
 on the unit is pressed, or a disc is 
inserted to activate the unit first.
6
Location of controls and basic operations
Main unit
This section contains instructions on the location 
of controls and basic operations.
For details, see the respective pages.
For optional device (CD/MD changer, etc.) 
operation, see “Using optional equipment” on 
page 10. The corresponding buttons on the card 
remote commander control the same functions as 
those on the unit.
A
OFF button
To power off; stop the source.
B
EQ3 (equalizer) button  page 9
To select an equalizer type (XPLOD, 
VOCAL, EDGE, CRUISE, SPACE, 
GRAVITY, CUSTOM or OFF).
C
Volume control dial/select button  
page 9
To adjust volume (rotate); select setup items 
(press and rotate).
D
SOURCE button
To power on; change the source* (Radio/CD/
AUX).
E
Disc slot
Insert the disc (label side up), playback 
starts.
F
Display window
G
AUX input jack  page 10
To connect a portable audio device.
H Z 
(eject) button
To eject the disc.
I
 (front panel release) button  page 5
SEEK
SEEK
PAUSE
REP
SHUF
EQ3
DSPL
OFF
BTM
PUSH SELECT
1
6
2
3
5
4
MODE
SOURCE
AUX
1
qa qs
q;
9
2
qd
qh
qg
4
5
8
6
7
3
qf
Page of 38
Display

Click on the first or last page to see other CDX-GT120 / CDX-GT220 / CDX-GT22W service manuals if exist.