Read Sony BDV-B1 / SA-WSB1 Service Manual online
SA-WSB1
3
CAPACITOR ELECTRICAL DISCHARGE PROCESSING
When checking the board, the electrical discharge is necessary for
the electric shock prevention.
Connect the resistor to both ends of respective capacitors.
When checking the board, the electrical discharge is necessary for
the electric shock prevention.
Connect the resistor to both ends of respective capacitors.
• SMPS
board
C903, C923, C934
– SMPS Board (Conductor Side) –
C934
C923
C903
Connect resistor
(about 100
(about 100
:/2 W)
for 2 seconds.
Connect resistor
(about 100
(about 100
:/15 W)
for 2 seconds.
Connect resistor
(about 1 k
(about 1 k
:/10 W)
for 3 seconds.
NOTE OF REPLACING THE BOARDS OR WIRELESS
MODULE
When the each boards or wireless module on SA-WSB1 are re-
placed, execute the pairing with HBD-B1.
MODULE
When the each boards or wireless module on SA-WSB1 are re-
placed, execute the pairing with HBD-B1.
Setting an ID for the wireless subwoofer
When the unit is manufactured, the ID is
already set. If interference occurs or you
use a new wireless subwoofer, an ID should
be set again.
1. Press HOME.
2. Use B/b to select the [Setup] and
already set. If interference occurs or you
use a new wireless subwoofer, an ID should
be set again.
1. Press HOME.
2. Use B/b to select the [Setup] and
press ENTER( ). The [Setup] menu
appears.
appears.
3. Use V/v to select [AUDIO] option then
press
b to move to the second level.
4. Use V/v to select the [Connect wireless
speakers] option then press ENTER( )
or
or
b to move to the third level.
The [Wireless Speaker Connection
Guide] appears.
Guide] appears.
5. Press PAIRING button on the
subwoofer.
- If you see the blue LED indicator light,
pairing was successful.
- If you see the blue LED indicator light,
pairing was successful.
6. Use B/b to select the [Speaker test] and
press ENTER( ) for wireless speaker
connection test.
connection test.
b Notes
• If there is a strong electromagnetic wave
product nearby, interference may occur. Put
the unit (Wireless subwoofer and main unit)
away from there.
the unit (Wireless subwoofer and main unit)
away from there.
• If you operate main unit then wireless
subwoofer (rear speakers) sound within a few
seconds in standby mode.
seconds in standby mode.
• Set the distance between this unit and
subwoofer Receiver within 10 m (32 ft.).
• Optimum performance can be implemented
only when the unit and the Wireless subwoofer
within distance of 2 m (6 ft.) to 10 m (32 ft.) is
used since communication failure may occur if
longer distance is used.
within distance of 2 m (6 ft.) to 10 m (32 ft.) is
used since communication failure may occur if
longer distance is used.
• It takes a few seconds (and may take longer)
for the Wireless Transmitter and subwoofer to
communicate with each other.
communicate with each other.
Click on the first or last page to see other BDV-B1 / SA-WSB1 service manuals if exist.