Read Sharp XG-NV5XE (serv.man42) Service Manual online
27
XG-NV5XE
XG-NV5XM
XG-NV5XM
No.
Adjusting point
Adjusting conditions
Adjusting procedure
27
RGB
performance
check
performance
check
1. Receive the RGB signal.
»
In the process mode and select L4. Check the pic-
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
ture, brightness, red, blue, clock, phase, horizontal
position, and vertical position.
28
Off-timer
performance
check
performance
check
»
In the process mode and select OFF. Make sure that
the off-timer starts with “5” (minutes), counts down
each minute in 1 second, and turns off the set at “0”.
the off-timer starts with “5” (minutes), counts down
each minute in 1 second, and turns off the set at “0”.
29
Thermistor
performance
check
performance
check
1. Heat the thermistor using a
dryer.
»
Make sure the “TEMP” is displayed.
S4
“Factory setting 4”
Remote controller
setting
setting
Process
adjustment
adjustment
»
Make the following settings.
33
Factory settings
30
Automatic
synchronization
synchronization
1. Receive the PHASE check
pattern signal.
»
Call the VGA/SVGA/XGA/SXGA mode and make
sure that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
sure that the clock, phase, horizontal and vertical
positions can be automatically adjusted.
31
IrDA
performance
check
performance
check
»
Make sure the IrDA signal can be received.
32
Keystone
correction
performance
check
correction
performance
check
»
Make sure the keystone correction functions well.