Read Sharp AR-PE2 (serv.man35) Technical Bulletin online
CCE076
Sharp Electronics (UK) Ltd., Technical Services Group
1.Model Name:
ARPE2
2.Description:
When the AR-PE2 (printer controller) is incorrectly installed to the AR-C160, the I/F cable
can be installed in the wrong direction. As a result, problems might arise.
To prevent this from happening, the AR-PE2 will be shipped with the I/F cable attached to
the IF card.
When installing the AR-PE2 (produced before October 2001) to the AR-C160, please be
very careful that the I/F cable is attached in the correct direction.
can be installed in the wrong direction. As a result, problems might arise.
To prevent this from happening, the AR-PE2 will be shipped with the I/F cable attached to
the IF card.
When installing the AR-PE2 (produced before October 2001) to the AR-C160, please be
very careful that the I/F cable is attached in the correct direction.
1) When connecting the I/F cable to the I/F card and controller, be sure to confirm the
direction of the cable by checking the label attached to the I/F cable (flat cable). (See
the picture shown below.)
the picture shown below.)
2) When fixing the two ground wires of the I/F cable, fix one wire with the mounting
screw on the I/F card side and fix the other with the mounting screw on the controller
side. (See the picture shown below.)
side. (See the picture shown below.)
* Be careful of the direction of the cable.
Connect the cable end with the "COPIER SIDE" label attached.
TECHNICAL BULLETIN
Date:
25 January 2002
Model: ARPE2
Ref.:
Ref.:
001
Colour: White
Page:
Page:
1 of 2
CHANGE OF SHIPMENT FORMAT
CCE076
Sharp Electronics (UK) Ltd., Technical Services Group
* Connect the cable end with the "CONTROLLER SIDE" label attached.
* Screw the ground wire of the I/F cable in the position shown in the figure.
* Screw the ground wire of the I/F cable in the position shown in the figure.
3.Action:
Applicable to the models produced since November 2001.
Display