Read Sharp R-23AM Service Manual online
R-23AM
8
“ . 0“ does not appear on display when power cord is plugged into
wall outlet.
Control panel can not accept key in.
Fuse F1 or F2 blows when the door is opened.
Home fuse blows when power cord is plugged into wall outlet.
Weak point F3 blows when power cord is plugged into wall outlet.
Oven lamp, fan motor and antenna motors do not work for 1
minute when the door is opened or after cooking.
Fuse F1 or F2 blows when power cord is plugged into wall outlet.
Oven lamp does not light when door is opened. (Blower and antenna
motors work)
Blower motor does not work when door is opened. (Oven lamp
lights and antenna motors work)
“EE 1” (Magnetron MG1 failure)
“EE 2” (Magnetron MG2 failure)
“EE 3” (Magnetron MG1 and MG2 failure)
“EE 6” (Exhaust thermistoropen)
“EE 7” (Exhaust air temperature is high)
“EE 9” (Exceeded max. heating time)
Oven lamp, blower motor and antenna motors do not work.
Oven lamp does not work.
Blower motor does not work.
Oven does not stop after end of cooking cycle.
Home fuse blows when starting the oven.
Oven goes into cook cycle but shuts down before end of cooking cycle.
It passed more than 1 minute after cooking but oven lamp, blower
motor and stirrer motors do not stop.
“EE 16” (Thermistor of magnetron are open.)
“EE 17” (Magnetron temperature is high.)
“EE 19” (Magnetron thermistor short)
“EE 10” (Fault of memory)
Antenna motors do not work.
TESTPROCEDURE
POSSIBLE CAUSE
AND
DEFECTIVE PARTS
CONDITION
OFF
CONDITION
ON
CONDITION
PROBLEM
EEP ROM I-2
N KEY
UNIT
TOUCH CONTROL TRANSFORMER T3
Due to programme lock
Over the max. cooking time
No power at wall outlet
HOME FUSE or BREAKER
Mis adjustment of switches
P FUSE
2.5A
O RELAY
RY-4
O RELAY
RY-3
O RELAY
RY-1
M TOUCH CONTROL PANEL
Opened wire harness
Shorted wire harness
POWER SUPPLY CORD
K NOISE
FILTER
OVEN LAMP OR SOCKET
J
BLOWER MOTOR BM
J
ANTENNA MOTORS SM
I
EXHAUST THERMISTOR TH3
I
MAGNETRON THERMISTOR (Lower) TH2
I
MAGNETRON THERMISTOR (Upper) TH1
L
HIGH VOLTAGE FUSE F5
L
HIGH VOLTAGE FUSE F4
H EXHAUST TEMPERATURE FUSE TF3
H MAGNETRON TEMPERATURE FUSE TF2
H MAGNETRON TEMPERATURE FUSE TF1
F
H MAGNETRON TEMPERATURE FUSE TF2
H MAGNETRON TEMPERATURE FUSE TF1
F
WEAK POINT F3
G FUSE F10A F2
G FUSE F10A F1
E
G FUSE F10A F1
E
STOP SWITCH SW5
E
MONITOR SWITCH SW4
E
MONITOR SWITCH SW3
E
NTERLOCK SWITCH SW2
D INTERLOCK SWITCH SW1
D H.V. CAPACITOR C2
D H.V. CAPACITOR C1
D H.V. CAPACITOR C2
D H.V. CAPACITOR C1
H.V. WIRE HARNESS
C H.V. RECTIFIER ASSEMBLY FOR MG2
C H.V. RECTIFIER ASSEMBLY FOR MG1
B
C H.V. RECTIFIER ASSEMBLY FOR MG1
B
HIGH VOLTAGE TRANSFORMER T2 (Rear)
B
HIGH VOLTAGE TRANSFORMER T1 (Front)
A
MAGNETRON MG2 (Lower)
A
MAGNETRON MG1 (Upper)
Click on the first or last page to see other R-23AM service manuals if exist.