Read Panasonic DMC-TZ5P / DMC-TZ5PC / DMC-TZ5PL / DMC-TZ5PR / DMC-TZ5EB / DMC-TZ5EE / DMC-TZ5EF / DMC-TZ5EG / DMC-TZ5E / DMC-TZ5SG / DMC-TZ15GC / DMC-TZ15GD / DMC-TZ15GK / DMC-TZ15GN / DMC-TZ15GT / DMC-TZ15GJ Service Manual online
DMC-TZ5PL
DMC-TZ5PR
DMC-TZ5EB
DMC-TZ5EE
DMC-TZ5EF
DMC-TZ5EG
DMC-TZ5E
DMC-TZ5SG
DMC-TZ15GC
DMC-TZ15GD
DMC-TZ15GK
DMC-TZ15GN
DMC-TZ15GT
DMC-TZ15GJ
(S)....................Silver Type (except PR/GD)
(K)....................Black Type
(A)....................Blue Type (only DMC-TZ5P/PC/PL/PR/
1.2. Leakage Current Cold Check--------------------------- 4
1.3. Leakage Current Hot Check (See Figure 1) -------- 4
1.4. How to Discharge the Capacitor on Flash
2.4. How to Replace the Lithium Battery ------------------ 8
3.2. General Description About Lead Free Solder
5 Location of Controls and Components ------------------15
6 Service Mode -----------------------------------------------------17
7.2. When Replacing the Main PCB -----------------------20
7.3. Service Position-------------------------------------------20
8.2. PCB Location ----------------------------------------------22
8.3. Disassembly Procedure---------------------------------23
8.4. Disassembly Procedure for the Lens ----------------28
8.5. Assembly Procedure for Lens -------------------------31
8.6. Removal of the CCD Unit-------------------------------35
8.7. Removal of the Zoom Motor Unit ---------------------36
8.8. Removal of the Focus Motor Unit --------------------36
8.9. The Applyment of grease Method --------------------37
which are important for safety. These parts are marked by
tial that these critical parts should be replaced with manu-
facturer’s specified parts to prevent X-RADIATION, shock
fire, or other hazards. Do not modify the original design
without permission of manufacturer.
from the AC power line. Use a transformer of adequate
power rating as this protects the technician from acci-
dents resulting in personal injury from electrical shocks. It
will also protect AC Adaptor from being damaged by acci-
dental shorting that may occur during servicing.
overheated or damaged by the short circuit.
properly installed.
shock hazards.
lic cabinet part on the equipment such as screwheads,
connectors, control shafts, etc. When the exposed metal-
lic part has a return path to the chassis, the reading
should be between 1M
(See Figure 1)
and a good earth ground, as shown in Figure 1.
lent) may be used to make the hot checks, leakage cur-
rent must not exceed 1/2 mA. In case a measurement is
outside of the limits specified, there is a possibility of a
shock hazard, and the equipment should be repaired and
rechecked before it is returned to the customer.