Read Panasonic DMC-LS80P / DMC-LS80PC / DMC-LS80PL / DMC-LS80E / DMC-LS80EB / DMC-LS80EE / DMC-LS80EF / DMC-LS80EG / DMC-LS80GC / DMC-LS80GK / DMC-LS80GN Service Manual online
DMC-LS80PC
DMC-LS80PL
DMC-LS80E
DMC-LS80EB
DMC-LS80EE
DMC-LS80EF
DMC-LS80EG
DMC-LS80GC
DMC-LS80GK
DMC-LS80GN
(S).............Silver Type (except DMC-LS80EF)
(K).............Black Type (except DMC-LS80EB/GK/GN)
(P).............Pink Type (except DMC-LS80EF/PC/GC/GN)
which are important for safety. These parts are marked by
tial that these critical parts should be replaced with manu-
facturer’s specified parts to prevent X-RADIATION,
shock, fire, or other hazards. Do not modify the original
design without permission of manufacturer.
from the AC power line. Use a transformer of adequate
power rating as this protects the technician from acci-
dents resulting in personal injury from electrical shocks. It
will also protect AC Adaptor from being damaged by acci-
dental shorting that may occur during servicing.
heated or damaged by the short circuit.
properly installed.
shock hazards.
lic cabinet part on the equipment such as screwheads,
connectors, control shafts, etc. When the exposed metal-
lic part has a return path to the chassis, the reading
should be between 1 M
reading must be infinity.
(See Figure 1.)
and a good earth ground, as shown in Figure 1.
lent) may be used to make the hot checks, leakage cur-
rent must not exceed 1/2 mA. In case a measurement is
outside of the limits specified, there is a possibility of a
shock hazard, and the equipment should be repaired and
rechecked before it is returned to the customer.
2. Be careful of the high voltage circuit on FLASH TOP PCB when servicing.
2. Put the insulation tube onto the lead part of Resistor (ERG5SJ102:1k
4. After discharging confirm that the capacitor voltage is lower than 10V using a voltmeter.
Sensitive (ES) Devices
trostatically Sensitive (ES) Devices.
(ESD).
which should be removed for potential shock reasons prior to applying power to the unit under test.
4. Use only an antistatic solder removal device. Some solder removal devices not classified as "antistatic (ESD protected)" can
6. Do not remove a replacement ES device from its protective package until immediately before you are ready to install it. (Most
ble conductive material).
CAUTION :
ficient to damage an ES device).