Read Panasonic WV-CU950 Service Manual online
1-4
●
Rear View
DC9V IN
MODE
DATA
SERIAL
CONTOROLLER
NO.
JOYSTICK
10/100 BASE-T
CAUTION
ATTENTION
CAUTION-
CONNECT TO
SPECIFED CLASS 2 POWER
SUPPLY ONLY. SEE MANUAL
SUPPLY ONLY. SEE MANUAL
$9
%0
$8
$7
$6
$5
%1
$5
Joystick connector (JOYSTICK)
This connector is used for connection with the joystick.
$6
Serial port (SERIAL)
This port is used for connection with a PC for system
configuration.
configuration.
$7
Data ports (DATA)
• These ports are used for connection with the system
controller and other system units via RS-485 communi-
cation.
cation.
• These ports used when adding other system controller
connections.
$8
Mode Selection switches (MODE)
The operation mode of system controller is selected
with these switches. (Refer to p. 24 for the setting.)
with these switches. (Refer to p. 24 for the setting.)
$9
Controller Number switch (CONTROLLER NO.)
When two or more system controllers are connected in
the system, this switch determines the unit number of
each controller. (Refer to p. 25 for the setting.) If con-
necting only one system controller in the system, set
this switch to “1”.
the system, this switch determines the unit number of
each controller. (Refer to p. 25 for the setting.) If con-
necting only one system controller in the system, set
this switch to “1”.
%0
DC 9V Input jack (DC 9V IN)
An AC adapter, supplied with the system controller, is
plugged into this jack.
plugged into this jack.
%1
10/100 Base-T port (10/100 BASE-T) (WV-CU950
only)
only)
This port is used for connection with Central Processing
Unit WJ-MPU855/850 via an Ethernet network.
Unit WJ-MPU855/850 via an Ethernet network.
LINK indicator:
This indicator lights up when the
system controller is linked to a network through this
port.
port.
ACT indicator:
This indicator lights up when the
system controller receives or sends data through
this port.
this port.
LINK indicator
ACT indicator
Click on the first or last page to see other WV-CU950 service manuals if exist.